+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Drawing of 6208-2RS1K: ⌀40 × ⌀80 × 18 mm6208-2RS1K2RS1
Fig. 1: 6208-2RS1K, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6208-2RS1K

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing SKF 6208-2RS1K

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
ISO designation
Equivalents
7 exact, 80 approximate
d
40 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
80 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
18 mm
Width BRing width. Source: supplier data
Seal
2RS1contact seals on both sides
Clearance
normal clearance
C
32.5 kN
Basic dynamic load rating CLoad for one million revolutions at 90 % reliability; the L10 life is calculated from it as (C/P)^p. ISO method, manufacturer’s figure: do not carry it over to another brand. Source: supplier data
01

Equivalents

the same size 40 × 80 × 18 from other brands

87 products
Series illustration (not a photo of this item): 6208-2RS1K
You are viewingSKF 6208-2RS1K

Everything the number specifies matches: series 62, 40 × 80 × 18 mm, contact seals on both sides, K, normal clearance, special design. The codes in the number are read against the SKF catalogue.
02

Details

what this bearing is, questions

About the bearing

D 80d 40B 18
d×D×Bsize 40 × 80 × 18mm
Cdynamic 32.5kN

Deep groove ball bearing 6208 K-2RS, design 2RS1: contact seals on both sides.

C: SKF data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

How does 2RS differ from ZZ?

2RS has rubber seals that touch the inner ring and keep out dust and water better, which is the usual choice for field machinery. ZZ has metal shields that do not touch, allow higher speeds, and protect against dirt less well.

Will 6208 2RS1 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet