+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
KBS
Drawing of 6208 2RS K: ⌀40 × ⌀80 × 18 mm6208 2RS K2RS
Fig. 1: 6208 2RS K, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6208 2RS K

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing KBS 6208 2RS K

€12.96per piece
Available to orderThe manager confirms the lead time
Request a quote

Specifications

Manufacturer number
ISO designation
Equivalents
7 exact, 80 approximate
d
40 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
80 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
18 mm
Width BRing width. Source: two supplier sources
Seal
2RSrubber, both sides
Clearance
normal clearance
m
0.37 kg
MassWeight of the product. Source: supplier data
01

Equivalents

the same size 40 × 80 × 18 from other brands

87 products
Photo: 6208 2RS K
You are viewingKBS 6208 2RS K
€12.96baseline for the price comparison

Everything the number specifies matches: series 62, 40 × 80 × 18 mm, contact seals on both sides, K, normal clearance, special design. The codes in the number are read against the KBS catalogue.

Under the price: the difference from the price of this bearing (€12.96).
02

Details

what this bearing is, questions

About the bearing

D 80d 40B 18
d×D×Bsize 40 × 80 × 18mm
mweight 0.37kg

Deep groove ball bearing 6208 K-2RS, design 2RS: contact seals on both sides.

M: KBS data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

How does 2RS differ from ZZ?

2RS has rubber seals that touch the inner ring and keep out dust and water better, which is the usual choice for field machinery. ZZ has metal shields that do not touch, allow higher speeds, and protect against dirt less well.

Will 6208 2RS C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet