CT belt
Exactsame number
SPZ · 833profile · Ld, mm
on request
available to orderV-belt SPZ 833
4 offers · 4 brandsPrices in euros incl. VATPrices include VAT at the Spain rate (21%); the cart recalculates VAT for your delivery country. Where there is no price, the page says “on request”: the manager names it after the call.
Section SPZ to DIN 7753-1 / ISO 4184; the supplier has no photos of these items.
NumberNarrow V-belt, profile SPZ · Drive and conveyor belts
SPZ 833
Narrow V-belt of profile SPZ, pitch length 833 mm. The number is not tied to a brand: SPZ 833 is made by 4 manufacturers from our catalogue, and the size is the same for all of them. Below are all offers for this number.
- LdPitch length Ld Length along the neutral line of the belt, this is the number in the part number. DIN catalogues call it Lw; the value is the same.
- 833 mm
- LaOutside length La Length along the back of the belt, the one a tape measure gives. For profile SPZ it is 13 mm longer than the pitch length.
- 846 mm
- wdPitch width wd Belt width at the neutral line. It equals the pitch width of the SPZ pulley groove: the belt and the pulley fit each other by it.
- 8.5 mm
- bTop width b Width of the belt back. Use it to check the profile of an old belt with calipers.
- 9.7 mm
- hHeight h Height of the section from the back to the bottom face of the wedge.
- 8 mm
4offersoffers
4brands
0with a price
0in stock
No filters: all offers for the number are shown
Same number SPZ 833: profile SPZ, pitch length 833 mm.0 of 4 in stock
Match is judged by profile, length and design from the number; a number with an undecoded suffix goes to “Check”.
SPZ 833Narrow V-belt
DELUX
Exactsame number
SPZ · 833profile · Ld, mm
on request
available to orderSPZ 833Narrow V-belt
Fenner/TOP DRIVE
Exactsame number
SPZ · 833profile · Ld, mm
on request
available to orderSPZ 833Narrow V-belt
POWERCLASSIC
Exactsame number
SPZ · 833profile · Ld, mm
on request
available to orderMatch is judged by profile, length and design from the number; a number with an undecoded suffix goes to “Check”.