+34 637 212 975 Mon–Fri 8:00–17:00 Madrid time Wishlist0 Compare0
€0.00
6030 · 150 × 225 × 35

Deep groove ball · 6030

radial — mediumaxial — low, on both sides
    Drawing of 6030: ⌀150 × ⌀225 × 35 mm6030
    Fig. 1: 6030, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

    There is no photo of this product: the 3D model and drawing show the dimensions of 6030

    Load: radial medium; axial low, on both sidesDeep groove ball

    Bearing FAG 6030

    Price on request
    Available to order
    Request a quoteIn the cart: send the request

    Specifications

    Manufacturer number
    GOST number
    Equivalents
    3 exact, 3 approximate
    d
    150 mm
    Bore diameter dBearing bore = shaft diameter. Source: supplier data
    D
    225 mm
    Outside diameter DOutside diameter = housing bore. Source: supplier data
    B
    35 mm
    Width BRing width. Source: supplier data
    Seal
    open, no protection
    Clearance
    normal clearance
    01

    Equivalents

    the same size 150 × 225 × 35 from other brands

    7 products
    Series illustration (not a photo of this item): 6030
    You are viewingFAG 6030

    Everything the number specifies matches: series 60, 150 × 225 × 35 mm, open, no protection, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the FAG catalogue.

    • Series illustration (not a photo of this item): 60306030This bearingFAG150 × 225 × 35available to orderon requestyou are here
    • Series illustration (not a photo of this item): 60306030CT150 × 225 × 3549 pcs€22.51
    • Series illustration (not a photo of this item): 60306030NTE150 × 225 × 355 pcs€36.19
    02

    Details

    what this bearing is, questions

    About the bearing

    D 225d 150B 35
    d×D×Bsize 150 × 225 × 35mm

    Deep groove ball bearing 6030. Under GOST the same bearing is designated 130.

    Frequently asked questions

    What is 130?

    It is the same bearing under GOST 3189-89: 130 corresponds to the ISO base 6030. Size 150 × 225 × 35 mm, a full equivalent of 6030.

    Will 6030 C3 fit instead?

    Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

    Can I fit another brand instead of this bearing?

    Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

    How do I get a price and a lead time?

    Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

    03

    Reviews

    No reviews yet