+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
Drawing of NJ 207 ECP: ⌀35 × ⌀72 × 17 mm⌀72⌀3517NJ 207 ECP
Fig. 1: NJ 207 ECP, end view and section; internal parts simplified per ISO 8826-1. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of NJ 207 ECP

Load: radial high; axial low, on one sideCylindrical roller NJ

Bearing SKF NJ 207 ECP

€27.50per piece
Available to orderThe manager confirms the lead time
Request a quote

Specifications

Manufacturer number
Equivalents
2 exact, 32 approximate
d
35 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
72 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
17 mm
Width BRing width. Source: two supplier sources
Seal
open, no protection
Clearance
normal clearance
C
56 kN
Basic dynamic load rating CLoad for one million revolutions at 90 % reliability; the L10 life is calculated from it as (C/P)^p. ISO method, manufacturer’s figure: do not carry it over to another brand. Source: supplier data
01

Equivalents

the same size 35 × 72 × 17 from other brands

37 products
Photo: NJ 207 ECP
You are viewingSKF NJ 207 ECP
€27.50baseline for the price comparison

Size and design match across the brand catalogues. The codes in the number are read against the SKF catalogue.

  • Photo: NJ 207 ECPNJ 207 ECPThis bearingSKF35 × 72 × 17available to order€27.50you are here
  • Series illustration (not a photo of this item): NJ 207 ECPNJ 207 ECPUTL35 × 72 × 17out of stockon requestRequest a quote

Under the price: the difference from the price of this bearing (€27.50).
02

Details

what this bearing is, questions

About the bearing

d×D×Bsize 35 × 72 × 17mm
Cdynamic 56kN

Cylindrical roller NJ bearing NJ 207 ECP.

C: SKF data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

Will 207 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet