+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
Drawing of 6316: ⌀80 × ⌀170 × 39 mm6316
Fig. 1: 6316, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6316

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing SKF 6316

€64.73per piece
Available to orderThe manager confirms the lead time
Request a quote

Specifications

Manufacturer number
GOST number
Equivalents
7 exact, 25 approximate
d
80 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
170 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
39 mm
Width BRing width. Source: two supplier sources
Seal
open, no protection
Clearance
normal clearance
C0
86.5 kN
Basic static load rating C0Permissible load without rotation and under shock; ISO 76 method, manufacturer’s figure. Source: supplier data
m
3.8 kg
MassWeight of the product. Source: supplier data
01

Equivalents

the same size 80 × 170 × 39 from other brands

32 products
Photo: 6316
You are viewingSKF 6316
€64.73baseline for the price comparison

Everything the number specifies matches: series 63, 80 × 170 × 39 mm, open, no protection, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the SKF catalogue.

Under the price: the difference from the price of this bearing (€64.73).
02

Details

what this bearing is, questions

About the bearing

D 170d 80B 39
d×D×Bsize 80 × 170 × 39mm
C0static 86.5kN
mweight 3.8kg

Deep groove ball bearing 6316. Under GOST the same bearing is designated 316.

C₀, m: SKF data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

What is 316?

It is the same bearing under GOST 3189-89: 316 corresponds to the ISO base 6316. Size 80 × 170 × 39 mm, a full equivalent of 6316.

Will 6316 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet