+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
Drawing of 6214: ⌀70 × ⌀125 × 24 mm6214
Fig. 1: 6214, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6214

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing SKF 6214

€35.28per piece
In stock: 5 pcs
Request a quote

Specifications

Manufacturer number
GOST number
Equivalents
6 exact, 22 approximate
d
70 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
125 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
24 mm
Width BRing width. Source: two supplier sources
Seal
open, no protection
Clearance
normal clearance
C0
45 kN
Basic static load rating C0Permissible load without rotation and under shock; ISO 76 method, manufacturer’s figure. Source: two supplier sources
01

Equivalents

the same size 70 × 125 × 24 from other brands

28 products
Photo: 6214
You are viewingSKF 6214
€35.28baseline for the price comparison

Everything the number specifies matches: series 62, 70 × 125 × 24 mm, open, no protection, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the SKF catalogue.

Under the price: the difference from the price of this bearing (€35.28).
02

Details

what this bearing is, questions

About the bearing

D 125d 70B 24
d×D×Bsize 70 × 125 × 24mm
C0static 45kN

Deep groove ball bearing 6214. Under GOST the same bearing is designated 214.

C₀: SKF data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

What is 214?

It is the same bearing under GOST 3189-89: 214 corresponds to the ISO base 6214. Size 70 × 125 × 24 mm, a full equivalent of 6214.

Will 6214 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet