+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Drawing of 6019: ⌀95 × ⌀145 × 24 mm6019
Fig. 1: 6019, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6019

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing SKF 6019

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
GOST number
Equivalents
2 exact, 13 approximate
d
95 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
145 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
24 mm
Width BRing width. Source: supplier data
Seal
open, no protection
Clearance
normal clearance
C
63.7 kN
Basic dynamic load rating CLoad for one million revolutions at 90 % reliability; the L10 life is calculated from it as (C/P)^p. ISO method, manufacturer’s figure: do not carry it over to another brand. Source: supplier data
01

Equivalents

the same size 95 × 145 × 24 from other brands

15 products
Series illustration (not a photo of this item): 6019
You are viewingSKF 6019

Everything the number specifies matches: series 60, 95 × 145 × 24 mm, open, no protection, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the SKF catalogue.

  • Series illustration (not a photo of this item): 60196019This bearingSKF95 × 145 × 24available to orderon requestyou are here
  • Photo: 60196019VBF95 × 145 × 24available to order€23.99Request a quote
02

Details

what this bearing is, questions

About the bearing

D 145d 95B 24
d×D×Bsize 95 × 145 × 24mm
Cdynamic 63.7kN

Deep groove ball bearing 6019. Under GOST the same bearing is designated 119.

C: SKF data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

What is 119?

It is the same bearing under GOST 3189-89: 119 corresponds to the ISO base 6019. Size 95 × 145 × 24 mm, a full equivalent of 6019.

Will 6019 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet