+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
Drawing of 6005: ⌀25 × ⌀47 × 12 mm6005
Fig. 1: 6005, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6005

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing SKF 6005

€2.30per piece
Available to orderThe manager confirms the lead time
Request a quote

Specifications

Manufacturer number
GOST number
Equivalents
3 exact, 58 approximate
d
25 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
47 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
12 mm
Width BRing width. Source: two supplier sources
Seal
open, no protection
Clearance
normal clearance
01

Equivalents

the same size 25 × 47 × 12 from other brands

64 products
Photo: 6005
You are viewingSKF 6005
€2.30baseline for the price comparison

Everything the number specifies matches: series 60, 25 × 47 × 12 mm, open, no protection, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the SKF catalogue.

  • Photo: 60056005This bearingSKF25 × 47 × 12available to order€2.30you are here
  • Series illustration (not a photo of this item): 60056005CT25 × 47 × 121,480 pcs€0.59−€1.71Request a quote
  • Series illustration (not a photo of this item): 60056005KG25 × 47 × 12available to orderon requestRequest a quote

Under the price: the difference from the price of this bearing (€2.30).
02

Details

what this bearing is, questions

About the bearing

D 47d 25B 12
d×D×Bsize 25 × 47 × 12mm

Deep groove ball bearing 6005. Under GOST the same bearing is designated 105.

Frequently asked questions

What is 105?

It is the same bearing under GOST 3189-89: 105 corresponds to the ISO base 6005. Size 25 × 47 × 12 mm, a full equivalent of 6005.

Will 6005 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet