+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Drawing of 23218 CCK/W33: ⌀90 × ⌀160 × 52.4 mm⌀160⌀9052.423218 CCK/W33
Fig. 1: 23218 CCK/W33, end view and section; internal parts simplified per ISO 8826-1. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 23218 CCK/W33

Load: radial high; axial medium, on both sidesSpherical roller

Bearing SKF 23218 CCK/W33

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
ISO designation
Equivalents
2 exact, 7 approximate
d
90 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
160 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
52.4 mm
Width BRing width. Source: supplier data
Seal
open, no protection
Clearance
normal clearance
C
355 kN
Basic dynamic load rating CLoad for one million revolutions at 90 % reliability; the L10 life is calculated from it as (C/P)^p. ISO method, manufacturer’s figure: do not carry it over to another brand. Source: supplier data
01

Equivalents

the same size 90 × 160 × 52.4 from other brands

9 products
Series illustration (not a photo of this item): 23218 CCK/W33
You are viewingSKF 23218 CCK/W33

Everything the number specifies matches: series 232, 90 × 160 × 52.4 mm, open, no protection, K, normal clearance, special design. The codes in the number are read against the SKF catalogue.

  • Series illustration (not a photo of this item): 23218 CCK/W3323218 CCK/W33This bearingSKF90 × 160 × 52.4available to orderon requestyou are here
  • Cross-section drawing to size: Spherical roller, 90 × 160 × 52.4 mm23218 CCKW33NTE90 × 160 × 52.4available to orderon requestRequest a quote
02

Details

what this bearing is, questions

About the bearing

d×D×Bsize 90 × 160 × 52.4mm
Cdynamic 355kN

Spherical roller bearing 23218 K.

C: SKF data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

Will 23218 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet