+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Drawing of 2314: ⌀70 × ⌀150 × 51 mm⌀150⌀70512314
Fig. 1: 2314, end view and section; internal parts simplified per ISO 8826-1. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 2314

Load: radial medium; axial low, on both sidesSelf-aligning ball

Bearing SKF 2314

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
GOST number
Equivalents
5 exact, 2 approximate
d
70 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
150 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
51 mm
Width BRing width. Source: supplier data
Seal
open, no protection
Clearance
normal clearance
C
111 kN
Basic dynamic load rating CLoad for one million revolutions at 90 % reliability; the L10 life is calculated from it as (C/P)^p. ISO method, manufacturer’s figure: do not carry it over to another brand. Source: supplier data
01

Equivalents

the same size 70 × 150 × 51 from other brands

8 products
Series illustration (not a photo of this item): 2314
You are viewingSKF 2314

Everything the number specifies matches: series 23, 70 × 150 × 51 mm, open, no protection, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the SKF catalogue.
02

Details

what this bearing is, questions

About the bearing

d×D×Bsize 70 × 150 × 51mm
Cdynamic 111kN

Self-aligning ball bearing 2314. Under GOST the same bearing is designated 1614.

C: SKF data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

What is 1614?

It is the same bearing under GOST 3189-89: 1614 corresponds to the ISO base 2314. Size 70 × 150 × 51 mm, a full equivalent of 2314.

Will 2314 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet