+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Drawing of 2207 EKTN9: ⌀35 × ⌀72 × 23 mm⌀72⌀35232207 EKTN9
Fig. 1: 2207 EKTN9, end view and section; internal parts simplified per ISO 8826-1. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 2207 EKTN9

Load: radial medium; axial low, on both sidesSelf-aligning ball

Bearing SKF 2207 EKTN9

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
ISO designation
GOST number
Equivalents
2 exact, 15 approximate
d
35 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
72 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
23 mm
Width BRing width. Source: supplier data
Seal
open, no protection
Clearance
normal clearance
C
30.7 kN
Basic dynamic load rating CLoad for one million revolutions at 90 % reliability; the L10 life is calculated from it as (C/P)^p. ISO method, manufacturer’s figure: do not carry it over to another brand. Source: supplier data
01

Equivalents

the same size 35 × 72 × 23 from other brands

18 products
Cross-section drawing to size: Self-aligning ball, 35 × 72 × 23 mm
You are viewingSKF 2207 EKTN9

Everything the number specifies matches: series 22, 35 × 72 × 23 mm, open, no protection, K, normal clearance, special design. The codes in the number are read against the SKF catalogue.

  • Cross-section drawing to size: Self-aligning ball, 35 × 72 × 23 mm2207 EKTN9This bearingSKF35 × 72 × 23available to orderon requestyou are here
  • Cross-section drawing to size: Self-aligning ball, 35 × 72 × 23 mm2207 Kno brand35 × 72 × 23available to orderon requestRequest a quote
02

Details

what this bearing is, questions

About the bearing

d×D×Bsize 35 × 72 × 23mm
Cdynamic 30.7kN

Self-aligning ball bearing 2207 K. Under GOST the same bearing is designated 111507.

C: SKF data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

What is 111507?

It is the same bearing under GOST 3189-89: 111507 corresponds to the ISO base 2207 K. Size 35 × 72 × 23 mm, a full equivalent of 2207 K.

Will 2207 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet