+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Drawing of 1215 K: ⌀75 × ⌀130 × 25 mm⌀130⌀75251215 K
Fig. 1: 1215 K, end view and section; internal parts simplified per ISO 8826-1. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 1215 K

Load: radial medium; axial low, on both sidesSelf-aligning ball

Bearing SKF 1215 K

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
GOST number
Equivalents
2 exact, 7 approximate
d
75 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
130 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
25 mm
Width BRing width. Source: supplier data
Seal
open, no protection
Clearance
normal clearance
C
39 kN
Basic dynamic load rating CLoad for one million revolutions at 90 % reliability; the L10 life is calculated from it as (C/P)^p. ISO method, manufacturer’s figure: do not carry it over to another brand. Source: supplier data
01

Equivalents

the same size 75 × 130 × 25 from other brands

10 products
Series illustration (not a photo of this item): 1215 K
You are viewingSKF 1215 K

Everything the number specifies matches: series 12, 75 × 130 × 25 mm, open, no protection, K, normal clearance, special design. The codes in the number are read against the SKF catalogue.

  • Series illustration (not a photo of this item): 1215 K1215 KThis bearingSKF75 × 130 × 25available to orderon requestyou are here
  • Series illustration (not a photo of this item): 1215 K1215 KCT75 × 130 × 2537 pcs€6.54Request a quote
02

Details

what this bearing is, questions

About the bearing

d×D×Bsize 75 × 130 × 25mm
Cdynamic 39kN

Self-aligning ball bearing 1215 K. Under GOST the same bearing is designated 111215.

C: SKF data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

What is 111215?

It is the same bearing under GOST 3189-89: 111215 corresponds to the ISO base 1215 K. Size 75 × 130 × 25 mm, a full equivalent of 1215 K.

Will 1215 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet