+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
NEUWEG
Drawing of 3308B-2RSRTNG: ⌀40 × ⌀90 × 36.5 mm⌀90⌀4036.53308B-2RSRTNG2RSR
Fig. 1: 3308B-2RSRTNG, end view and section; internal parts simplified per ISO 8826-1. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 3308B-2RSRTNG

Combined load at an angle (angular contact), axial on one sideAngular contact ball

Bearing NEUWEG 3308B-2RSRTNG

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
ISO designation
Equivalents
2 exact, 12 approximate
d
40 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
90 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
36.5 mm
Width BRing width. Source: supplier data
Seal
2RSRcontact seals on both sides
01

Equivalents

the same size 40 × 90 × 36.5 from other brands

14 products
Cross-section drawing to size: Angular contact ball, 40 × 90 × 36.5 mm
You are viewingNEUWEG 3308B-2RSRTNG

Everything the number specifies matches: series 33, 40 × 90 × 36.5 mm, contact seals on both sides, special design; any contact angle. The codes in the number are read against the NEUWEG catalogue.

  • Cross-section drawing to size: Angular contact ball, 40 × 90 × 36.5 mm3308B-2RSRTNGThis bearingNEUWEG40 × 90 × 36.5available to orderon requestyou are here
  • Cross-section drawing to size: Angular contact ball, 40 × 90 × 36.5 mm3308 2RS TNGCT40 × 90 × 36.591 pcs€4.67Request a quote
02

Details

what this bearing is, questions

About the bearing

D 90d 40B 36.5
d×D×Bsize 40 × 90 × 36.5mm

Angular contact ball bearing 3308 B-2RS, design 2RSR: contact seals on both sides.

Frequently asked questions

How does 2RS differ from ZZ?

2RS has rubber seals that touch the inner ring and keep out dust and water better, which is the usual choice for field machinery. ZZ has metal shields that do not touch, allow higher speeds, and protect against dirt less well.

Will 3308 2RSR C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet