+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
MTM
Drawing of 6012 2RS: ⌀60 × ⌀95 × 18 mm6012 2RS2RS
Fig. 1: 6012 2RS, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6012 2RS

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing MTM 6012 2RS

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
ISO designation
GOST number
Equivalents
11 exact, 19 approximate
d
60 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
95 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
18 mm
Width BRing width. Source: supplier data
Seal
2RSrubber, both sides
Clearance
normal clearance
01

Equivalents

the same size 60 × 95 × 18 from other brands

31 products
Series illustration (not a photo of this item): 6012 2RS
You are viewingMTM 6012 2RS

Everything the number specifies matches: series 60, 60 × 95 × 18 mm, contact seals on both sides, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the MTM catalogue.
02

Details

what this bearing is, questions

About the bearing

D 95d 60B 18
d×D×Bsize 60 × 95 × 18mm

Deep groove ball bearing 6012-2RS, design 2RS: contact seals on both sides. Under GOST the same bearing is designated 180112.

Frequently asked questions

How does 2RS differ from ZZ?

2RS has rubber seals that touch the inner ring and keep out dust and water better, which is the usual choice for field machinery. ZZ has metal shields that do not touch, allow higher speeds, and protect against dirt less well.

What is 180112?

It is the same bearing under GOST 3189-89: 18 — contact seals on both sides, 0112 corresponds to the ISO base 6012. Size 60 × 95 × 18 mm, a full equivalent of 6012-2RS.

Will 6012 2RS C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet