+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
KLT
Drawing of 6202 ZZ: ⌀15 × ⌀35 × 11 mm6202 ZZZZ
Fig. 1: 6202 ZZ, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm
Bearing KLT 6202 ZZ — photo 1
Load: radial medium; axial low, on both sidesDeep groove ball

Bearing KLT 6202 ZZ

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
ISO designation
GOST number
Equivalents
11 exact, 83 approximate
d
15 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
35 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
11 mm
Width BRing width. Source: two supplier sources
Seal
ZZshields, both sides
Clearance
normal clearance
m
0.045 kg
MassWeight of the product. Source: supplier data
01

Equivalents

the same size 15 × 35 × 11 from other brands

100 products
Photo: 6202 ZZ
You are viewingKLT 6202 ZZ

Everything the number specifies matches: series 62, 15 × 35 × 11 mm, metal shields on both sides, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the KLT catalogue.
02

Details

what this bearing is, questions

About the bearing

D 35d 15B 11
d×D×Bsize 15 × 35 × 11mm
mweight 0.045kg

Deep groove ball bearing 6202-ZZ, design ZZ: metal shields on both sides. Under GOST the same bearing is designated 80202.

M: KLT data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

How does 2RS differ from ZZ?

2RS has rubber seals that touch the inner ring and keep out dust and water better, which is the usual choice for field machinery. ZZ has metal shields that do not touch, allow higher speeds, and protect against dirt less well.

What is 80202?

It is the same bearing under GOST 3189-89: 8 — metal shields on both sides, 0202 corresponds to the ISO base 6202. Size 15 × 35 × 11 mm, a full equivalent of 6202-ZZ.

Will 6202 ZZ C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet