+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
Drawing of 6218: ⌀90 × ⌀160 × 30 mm6218
Fig. 1: 6218, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6218

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing FAG 6218

€78.98per piece
Available to orderThe manager confirms the lead time
Request a quote

Specifications

Manufacturer number
GOST number
Equivalents
8 exact, 26 approximate
d
90 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
160 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
30 mm
Width BRing width. Source: two supplier sources
Seal
open, no protection
Clearance
normal clearance
m
2.15 kg
MassWeight of the product. Source: two supplier sources
01

Equivalents

the same size 90 × 160 × 30 from other brands

35 products
Photo: 6218
You are viewingFAG 6218
€78.98baseline for the price comparison

Everything the number specifies matches: series 62, 90 × 160 × 30 mm, open, no protection, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the FAG catalogue.

Under the price: the difference from the price of this bearing (€78.98).
02

Details

what this bearing is, questions

About the bearing

D 160d 90B 30
d×D×Bsize 90 × 160 × 30mm
mweight 2.15kg

Deep groove ball bearing 6218. Under GOST the same bearing is designated 218.

M: FAG data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

What is 218?

It is the same bearing under GOST 3189-89: 218 corresponds to the ISO base 6218. Size 90 × 160 × 30 mm, a full equivalent of 6218.

Will 6218 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet