+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Drawing of 6204.2RSR: ⌀20 × ⌀47 × 14 mm6204.2RSR2RSR
Fig. 1: 6204.2RSR, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6204-2RSR

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing FAG 6204-2RSR

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
ISO designation
GOST number
Equivalents
15 exact, 96 approximate
d
20 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
47 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
14 mm
Width BRing width. Source: supplier data
Seal
2RSRcontact seals on both sides
Clearance
normal clearance
01

Equivalents

the same size 20 × 47 × 14 from other brands

118 products
Series illustration (not a photo of this item): 6204.2RSR
You are viewingFAG 6204-2RSR

Everything the number specifies matches: series 62, 20 × 47 × 14 mm, contact seals on both sides, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the FAG catalogue.
02

Details

what this bearing is, questions

About the bearing

D 47d 20B 14
d×D×Bsize 20 × 47 × 14mm

Deep groove ball bearing 6204-2RS, design 2RSR: contact seals on both sides. Under GOST the same bearing is designated 180204.

Frequently asked questions

How does 2RS differ from ZZ?

2RS has rubber seals that touch the inner ring and keep out dust and water better, which is the usual choice for field machinery. ZZ has metal shields that do not touch, allow higher speeds, and protect against dirt less well.

What is 180204?

It is the same bearing under GOST 3189-89: 18 — contact seals on both sides, 0204 corresponds to the ISO base 6204. Size 20 × 47 × 14 mm, a full equivalent of 6204-2RS.

Will 6204 2RSR C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet