+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
DYZV
Drawing of 6226: ⌀130 × ⌀230 × 40 mm6226
Fig. 1: 6226, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6226

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing DYZV 6226

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
GOST number
Equivalents
4 exact, 7 approximate
d
130 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
230 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
40 mm
Width BRing width. Source: supplier data
Seal
open, no protection
Clearance
normal clearance
01

Equivalents

the same size 130 × 230 × 40 from other brands

11 products
Series illustration (not a photo of this item): 6226
You are viewingDYZV 6226

Everything the number specifies matches: series 62, 130 × 230 × 40 mm, open, no protection, normal clearance, ordinary steel, design without special letters. The codes in the number are read against the DYZV catalogue.

  • Series illustration (not a photo of this item): 62266226This bearingDYZV130 × 230 × 40available to orderon requestyou are here
  • Series illustration (not a photo of this item): 62266226CT130 × 230 × 40available to orderon requestRequest a quote
  • Series illustration (not a photo of this item): 62266226KG130 × 230 × 40available to orderon requestRequest a quote
  • Series illustration (not a photo of this item): 62266226SKF130 × 230 × 40available to orderon requestRequest a quote
02

Details

what this bearing is, questions

About the bearing

D 230d 130B 40
d×D×Bsize 130 × 230 × 40mm

Deep groove ball bearing 6226. Under GOST the same bearing is designated 226.

Frequently asked questions

What is 226?

It is the same bearing under GOST 3189-89: 226 corresponds to the ISO base 6226. Size 130 × 230 × 40 mm, a full equivalent of 6226.

Will 6226 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet