+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
Drawing of SS 6002 2RS: ⌀15 × ⌀32 × 9 mmSS 6002 2RS2RS
Fig. 1: SS 6002 2RS, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of SS 6002 2RS

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing CT SS 6002 2RS

€0.85per piece
In stock: 3,984 pcs
Request a quote

Specifications

Manufacturer number
ISO designation
Equivalents
2 exact, 45 approximate
d
15 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
32 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
9 mm
Width BRing width. Source: two supplier sources
Seal
2RSrubber, both sides
Clearance
normal clearance
01

Equivalents

the same size 15 × 32 × 9 from other brands

52 products
Drawing: SS 6002 2RS
You are viewingCT SS 6002 2RS
€0.85baseline for the price comparison

Everything the number specifies matches: series 60, 15 × 32 × 9 mm, contact seals on both sides, normal clearance, stainless steel. The codes in the number are read against the CT catalogue.

  • Drawing: SS 6002 2RSSS 6002 2RSThis bearingCT15 × 32 × 93,984 pcs€0.85you are here
  • Drawing: 6002 2RS SS6002 2RS SSno brand15 × 32 × 9available to orderon requestRequest a quote

Under the price: the difference from the price of this bearing (€0.85).
02

Details

what this bearing is, questions

About the bearing

D 32d 15B 9
d×D×Bsize 15 × 32 × 9mm

Deep groove ball bearing 6002-2RS SS, design 2RS: contact seals on both sides.

Frequently asked questions

How does 2RS differ from ZZ?

2RS has rubber seals that touch the inner ring and keep out dust and water better, which is the usual choice for field machinery. ZZ has metal shields that do not touch, allow higher speeds, and protect against dirt less well.

Will 6002 2RS C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet