+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
Drawing of NU 314 E: ⌀70 × ⌀150 × 35 mm⌀150⌀7035NU 314 E
Fig. 1: NU 314 E, end view and section; internal parts simplified per ISO 8826-1. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of NU 314 E

Load: radial high; no axial loadCylindrical roller NU

Bearing CT NU 314 E

€11.56per piece
In stock: 98 pcs
Request a quote

Specifications

Manufacturer number
Equivalents
2 exact, 36 approximate
d
70 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
150 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
35 mm
Width BRing width. Source: two supplier sources
Seal
open, no protection
Clearance
normal clearance
C
236 kN
Basic dynamic load rating CLoad for one million revolutions at 90 % reliability; the L10 life is calculated from it as (C/P)^p. ISO method, manufacturer’s figure: do not carry it over to another brand. Source: supplier data
01

Equivalents

the same size 70 × 150 × 35 from other brands

46 products
Series illustration (not a photo of this item): NU 314 E
You are viewingCT NU 314 E
€11.56baseline for the price comparison

Size and design match across the brand catalogues. The codes in the number are read against the CT catalogue.

  • Series illustration (not a photo of this item): NU 314 ENU 314 EThis bearingCT70 × 150 × 3598 pcs€11.56you are here
  • Series illustration (not a photo of this item): NU 314 ENU 314 Eno brand70 × 150 × 35available to orderon requestRequest a quote

Under the price: the difference from the price of this bearing (€11.56).
02

Details

what this bearing is, questions

About the bearing

d×D×Bsize 70 × 150 × 35mm
Cdynamic 236kN

Cylindrical roller NU bearing NU 314 E.

C: CT data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

Will 314 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet