+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Drawing of NJ 226: ⌀130 × ⌀230 × 40 mm⌀230⌀13040NJ 226
Fig. 1: NJ 226, end view and section; internal parts simplified per ISO 8826-1. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of NJ 226

Load: radial high; axial low, on one sideCylindrical roller NJ

Bearing CT NJ 226

Price on request
Available to order
Request a quote

Specifications

Manufacturer number
Equivalents
4 exact, 19 approximate
d
130 mm
Bore diameter dBearing bore = shaft diameter. Source: supplier data
D
230 mm
Outside diameter DOutside diameter = housing bore. Source: supplier data
B
40 mm
Width BRing width. Source: supplier data
Seal
open, no protection
Clearance
normal clearance
C
364 kN
Basic dynamic load rating CLoad for one million revolutions at 90 % reliability; the L10 life is calculated from it as (C/P)^p. ISO method, manufacturer’s figure: do not carry it over to another brand. Source: supplier data
01

Equivalents

the same size 130 × 230 × 40 from other brands

23 products
Cross-section drawing to size: Cylindrical roller NJ, 130 × 230 × 40 mm
You are viewingCT NJ 226

Size and design match across the brand catalogues. The codes in the number are read against the CT catalogue.

  • Cross-section drawing to size: Cylindrical roller NJ, 130 × 230 × 40 mmNJ 226This bearingCT130 × 230 × 40available to orderon requestyou are here
  • Series illustration (not a photo of this item): NJ226ENJ226EDYZV130 × 230 × 40available to orderon requestRequest a quote
  • Cross-section drawing to size: Cylindrical roller NJ, 130 × 230 × 40 mmNJ226EMDYZV130 × 230 × 40available to orderon requestRequest a quote
  • Cross-section drawing to size: Cylindrical roller NJ, 130 × 230 × 40 mmNJ 226 ECJSKF130 × 230 × 40available to orderon requestRequest a quote
02

Details

what this bearing is, questions

About the bearing

d×D×Bsize 130 × 230 × 40mm
Cdynamic 364kN

Cylindrical roller NJ bearing NJ 226.

C: CT data. Another brand publishes its own figures, so compare them against that brand’s catalogue.

Frequently asked questions

Will 226 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet