+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
Drawing of 1211 K: ⌀55 × ⌀100 × 21 mm⌀100⌀55211211 K
Fig. 1: 1211 K, end view and section; internal parts simplified per ISO 8826-1. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 1211 K

Load: radial medium; axial low, on both sidesSelf-aligning ball

Bearing CT Malaysia 1211 K

€2.76per piece
In stock: 25 pcs
Request a quote

Specifications

Manufacturer number
GOST number
Equivalents
2 exact, 12 approximate
d
55 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
100 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
21 mm
Width BRing width. Source: two supplier sources
Seal
open, no protection
Clearance
normal clearance
01

Equivalents

the same size 55 × 100 × 21 from other brands

17 products
Series illustration (not a photo of this item): 1211 K
You are viewingCT 1211 K
€2.76baseline for the price comparison

Everything the number specifies matches: series 12, 55 × 100 × 21 mm, open, no protection, K, normal clearance, special design. The codes in the number are read against the CT catalogue.

  • Series illustration (not a photo of this item): 1211 K1211 KThis bearingCT55 × 100 × 2125 pcs€2.76you are here
  • Series illustration (not a photo of this item): 1211 K1211 Kno brand55 × 100 × 21available to orderon requestRequest a quote

Under the price: the difference from the price of this bearing (€2.76).
02

Details

what this bearing is, questions

About the bearing

d×D×Bsize 55 × 100 × 21mm

Self-aligning ball bearing 1211 K. Under GOST the same bearing is designated 111211.

Frequently asked questions

What is 111211?

It is the same bearing under GOST 3189-89: 111211 corresponds to the ISO base 1211 K. Size 55 × 100 × 21 mm, a full equivalent of 1211 K.

Will 1211 C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet