+380 50 364 66 46 Mon–Fri 8:00–17:00 Kyiv time Wishlist0 Compare0
Prices are in euros. The final price and delivery cost are confirmed in the quote.
Drawing of 6008 2RS: ⌀40 × ⌀68 × 15 mm6008 2RS2RS
Fig. 1: 6008 2RS, end view and section; rolling element geometry per the NSK catalogue. Dimensions in mm

There is no photo of this product: the drawing shows the dimensions of 6008 2RS

Load: radial medium; axial low, on both sidesDeep groove ball

Bearing 6008 2RS

€0.95per piece
In stock: 8 pcs
Request a quote

Specifications

Manufacturer number
ISO designation
GOST number
Equivalents
11 exact, 39 approximate
d
40 mm
Bore diameter dBearing bore = shaft diameter. Source: two supplier sources
D
68 mm
Outside diameter DOutside diameter = housing bore. Source: two supplier sources
B
15 mm
Width BRing width. Source: two supplier sources
Seal
2RSrubber, both sides
Clearance
normal clearance
01

Equivalents

the same size 40 × 68 × 15 from other brands

52 products
Series illustration (not a photo of this item): 6008 2RS
You are viewing6008 2RS
€0.95baseline for the price comparison

Everything the number specifies matches: series 60, 40 × 68 × 15 mm, contact seals on both sides, normal clearance, ordinary steel, design without special letters.

Under the price: the difference from the price of this bearing (€0.95).
02

Details

what this bearing is, questions

About the bearing

D 68d 40B 15
d×D×Bsize 40 × 68 × 15mm

Deep groove ball bearing 6008-2RS, design 2RS: contact seals on both sides. Under GOST the same bearing is designated 180108.

Frequently asked questions

How does 2RS differ from ZZ?

2RS has rubber seals that touch the inner ring and keep out dust and water better, which is the usual choice for field machinery. ZZ has metal shields that do not touch, allow higher speeds, and protect against dirt less well.

What is 180108?

It is the same bearing under GOST 3189-89: 18 — contact seals on both sides, 0108 corresponds to the ISO base 6008. Size 40 × 68 × 15 mm, a full equivalent of 6008-2RS.

Will 6008 2RS C3 fit instead?

Same size, clearance greater than normal. C3 is used where the bearing runs hot or sits on the shaft with an interference fit. If the old bearing is not marked C3, take this one.

Can I fit another brand instead of this bearing?

Without checking, only an exact equivalent: the size, seal, clearance and design match according to the brand’s catalogue. Positions with the same geometry differ in seal, clearance or design, and each one says so in the equivalents block. Load ratings differ between manufacturers, so for a heavily loaded unit compare C.

How do I get a price and a lead time?

Press “Request a quote” and send the part number and quantity. We reply with the price, availability and delivery terms for your country.

03

Reviews

No reviews yet